Lexmark Dot Matrix Technical Reference - Page 182
parameter to be ignored. No human, which causes the b1 bit value of
View all Lexmark Dot Matrix manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 182 highlights
• When the m parameter is set to 1 (m = 1), the printer does not print the human readable character. Example: Although the c parameter has a value of x00, which tells the printer to print the human readable character, the m parameter has a value of x01, which causes the b1 bit value of the c parameter to be ignored. No human readable character is printed. • Be cautious when sending commands to change the page length and margins. The barcode print area cannot exceed the page length, bottom margin, or right margin. 182 Section 8: Barcodes
Section 8: Barcodes
182
•
When the
m
parameter is set to 1 (
m
= 1), the printer does not print the
human readable character.
Example:
Although the
c
parameter has a value of
x00
, which tells the printer to
print the human readable character, the
m
parameter has a value of
x01
,
which causes the b1 bit value of the
c
parameter to be ignored. No human
readable character is printed.
•
Be cautious when sending commands to change the page length and mar-
gins. The barcode print area cannot exceed the page length, bottom mar-
gin, or right margin.
<x
1B5B66
-
barcode setup command prefix
0600
-
setup data length (low byte first) -
x0006, 6
B4
-
barcode type = Code 39
01
-
module width = 1 = 0.017 inches for 248x
0.012 inches for 249x
00
-
space width adjustment = default
3804
-
height (low byte first) - x0438= 0.50
inches
00
-
control byte: check digit by host, print
human readable character
>