Lexmark Dot Matrix Technical Reference - Page 60
Set Skip Perforation, Cancel Skip Perforation
View all Lexmark Dot Matrix manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
• When the command is sent, the current vertical position becomes the new top of form. • If the printer command Set Skip Perforation (ESC N) is active, or if "skip over perforation" is On in the printer setup, this printer command deactivates it. Set Skip Perforation This command specifies the number of lines to be skipped at the bottom of each page, which creates a bottom margin. Format ESC N lines Decimal 27 78 n Hex 1B 4E n Usage Notes • This command remains in effect until: - Cancel Skip Perforation (ESC O) printer command is received. - Set Page Length in Lines (ESC C) printer command is received. - Set Page Length in Inches (ESC C 0) printer command is received. • Valid values for n are 1 through 255 (decimal), 01 through FF (hexadecimal). • To cancel this printer command, use Cancel Skip Perforation (ESC O). Cancel Skip Perforation This command cancels Set Skip Perforation (ESC N). Format ESC O Decimal 27 79 Hex 1B 4F 60 Section 3: IBM Emulation Mode Printer Commands