Lexmark T430 User's Guide - Page 150
Solving printing problems, Problem, Solution
View all Lexmark T430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
Troubleshooting Solving printing problems Problem Solution The printer prints slowly when Best The higher the quality you select, the slower the print job will print. If quality is chosen in the printer speed is necessary, choose Draft or Normal as the quality setting. Using driver. Best slows the printer to about half the speed of Normal. The printer prints slowly when printing on narrow media (less than 182 mm [7.2 in.] wide). Narrow print media causes the printer to feed more slowly. If speed is necessary, print on wider media. The printer prints slowly when printing on transparencies. The printer slows down to optimize print quality. Changing the Media Type setting back to Plain Paper increases the speed, but transparencies may stick together in the output tray. The printer does not print at all or prints black splotches down the right side of a page. Make sure that the upper front door is fully closed on both sides. If the left side of the door is not fully closed, the printer will not print. If the right side of the door is not fully closed, black splotches may print down the right side of a page. Job did not print or incorrect characters printed. • Make sure Ready appears on the operator panel before you send a job to print. Press Go to return to Ready. • Make sure print media is loaded in the printer. See Loading trays and Loading and using the multipurpose feeder. Press Continue. • Verify that the printer is using the correct printer language. • Verify that the correct printer driver is being used. • Make sure the parallel cable or USB cable is firmly plugged in at the back of the printer. • Check the cable connections. • Make sure you are using the correct cable. If you use the parallel port, we recommend an IEEE 1284-compliant parallel cable such as Lexmark part number 1329605 (10 ft) or 1427498 (20 ft). If you use the USB port, we recommend the cable with Lexmark part number 12A2405 (2 m). • If the printer is connected through a switch box, try a direct connection. • Verify that the correct print media size is selected in the printer driver or on the operator panel. • Make sure PCL SmartSwitch and PS SmartSwitch are set to On in the printer driver or on the operator panel. • If a print spooler is used, verify that the spooler is not stalled. • If you print across a network or on a Macintosh computer, see Solving network printing problems. • Determine which host interface you are using. Solving printing problems 150