LiftMaster 3850 3850 Elite Series Manual - Page 22
ALL ONE-PIECE DOORS, Assemble the Door Arm - review
View all LiftMaster 3850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
ALL ONE-PIECE DOORS 1. Assemble the Door Arm: • Fasten the straight and curved door arm sections together to the longest possible length (with a 2 or 3 hole overlap). • Make sure the garage door is fully closed. Connect the straight door arm section to the door bracket with the 5/16"x1-1/4" clevis pin. • Secure with a ring fastener. • Pull the emergency release handle, disconnecting the outer trolley from the inner trolley by pulling straight down on the emergency release handle and sliding the outer trolley back toward the motor unit. • Connect the curved door arm section to the trolley using the 5/16"x1-1/4" clevis pin and ring fastener. NOTE: Adjusting the limits on the following page: • The trolley will automatically connect. If not, review the trolley lockout feature on page 27. • When setting the up limit on the following page, the door should not have a "backward" slant when fully open as illustrated below. A slight backward slant will cause unnecessary bucking and/or jerking operation as the door is being opened or closed from the fully open position. Figure 4 Door Bracket Clevis Pin 5/16"x1-1/4" Ring Fastener Straight Arm Bolts 5/16"-18x7/8 Lock Washers 5/16" Nuts 5/16"-18 Curved Door Arm Figure 5 Inner Trolley Outer Trolley Door Arm Door Arm Connector Hole Emergency Release Handle Closed Door Inner Trolley Outer Trolley Correct Angle Door Arm Open Door Door with Backward Slant (Incorrect) 22