LiftMaster 3850 3850 Elite Series Manual - Page 34
Programming, To Add or Reprogram a Hand-held Remote Control, To Erase All Codes From Motor Unit Memory
View all LiftMaster 3850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
PROGRAMMING NOTICE: If this Security✚® garage door opener is operated with a non-rolling code remote control, the technical measure in the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code remote control to circumvent that technical measure. Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will open and close when you press the large push button. Below are instructions for programming your opener to operate with additional 315 MHz Security✚® remote controls. USING THE "LEARN" BUTTON To Add or Reprogram a Hand-held Remote Control USING THE DOOR CONTROL LOCK LIGHT LOCK LIGHT 1. Press and release the "learn" button on the motor unit. The learn indicator light will glow steadily for 30 seconds. 2. Within 30 seconds, press and hold the button on the hand-held remote* that you wish to operate your garage door. 3. Release the button when the motor unit lights blink. It has learned the code. If light bulbs are not installed, two clicks will be heard. To Erase All Codes From Motor Unit Memory To deactivate any unwanted remote, first erase all codes: Press and hold the "learn" button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use. 1. Press the PROG button on the door control. 2. Press the PROG button again to confirm Learn Mode. 3. Press the button on the hand-held remote that you wish to operate your garage door. LOCK LIGHT LOCK LIGHT 4. When the motor unit lights blink, it has learned the code. If light bulbs are not installed, two clicks will be heard. *3-Button Remotes (315 MHz) If provided with your garage door opener, the large button is factory programmed to operate it. Additional buttons on any Security✚® 3-button remote or mini-remote can be programmed to operate other Security✚® garage door openers. 34