LiftMaster CAPXS Installation Manual - English French Spanish - Page 15
Access Control, Door Access, Request To Exit, Power, Postal Lock, Primary Relay, Auxiliary Relay
View all LiftMaster CAPXS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
INTRODUCTION ACCOUNT SETUP POWER NETWORK/MOUNTING ACCESS CONTROL Door Access Disconnect power BEFORE making electrical connections. Below is an example of a wiring setup for door access. WIEGAND KEYPAD READER OR NOTE: For KPR2000 keypad wire the pink and black (ground) wires together. SUPERVISED (DOOR STATUS) DOOR SENSOR (SUPERVISED) EOL (End of Line) Resistor (1k ohm) REQUEST TO EXIT PROXIMITY PUSH SENSOR BUTTON OR OR DOOR SENSOR (NON-SUPERVISED) REQUEST TO EXIT GROUND SUPERVISED *PRIMARY RELAY DOOR STRIKE For AC Power: Install a Siemens S10K30MOV (Metal Oxide Varistor) or equivalent Power for Door Strike (Not Provided) Use 18-22 AWG COMMON + 12 VDC POWER SUPPLY NOTE: The length of the unshielded wires should be kept to a minimum to avoid electrical noise. POSTAL LOCK** POSTAL LOCK POWER GROUND POWER NORMALLY OPEN (N.O.) COMMON (COM) GROUND (BLACK GND) DATA 0 (GREEN DATA0) DATA 1 (WHITE DATA1) REQUEST TO EXIT (REX) GROUND (GND) SUPERVISED NORMALLY OPEN (N.O) COMMON (COM) NORMALLY CLOSED (N.C.) NORMALLY OPEN (N.O.) COMMON (COM) - - For DC Power: Install a 1N4005 diode or equivalent NORMALLY OPEN OR MAGLOCK For AC Power: Install a Siemens S10K30MOV (Metal Oxide Varistor) or equivalent Use 18-22 AWG NORMALLY CLOSED COMMON + AUXILIARY RELAY Low Voltage Power Supply LIGHT Isolation Relay LOAD LINE NEUTRAL NOTE: DO NOT connect high voltage power OR to the CAPXS unit. ALARM BYPASS ETHERNET CONNECTION DO NOT INSTALL THE SYSTEM IN THE FAIL SECURE MODE UNLESS PERMITTED BY THE LOCAL AUTHORITY HAVING JURISDICTION. Doing so may cause interference with the operation of panic hardware. For DC Power: Install a 1N4005 diode or equivalent Power for Maglock (Not Provided) DO NOT use the power supply for the controller 15 COMMON NORMALLY OPEN * NOTE: MAGLOCK, door strike and ALARM BYPASS not evaluated by UL. ** NOTE: For more information on how to wire in a postal lock, refer to the manual for accessory: CAPXSTKPL.