LiftMaster CAPXS Installation Manual - English French Spanish - Page 16

INTRODUCTION ACCOUNT SETUP POWER NETWORK/MOUNTING ACCESS CONTROL Gate Access (Wired) Disconnect power BEFORE making electrical connections. Below is an example of a wiring setup for gate access. WIEGAND KEYPAD READER OR NOTE: For KPR2000 keypad wire the pink and black (ground) wires together. SUPERVISED (GATE STATUS) (Not applicable for wireless gate operator connections) GATE OPERATOR (connect to Aux Closed Limit switch - refer to gate operator manual) EOL (End of Line) Resistor (1k ohm) REQUEST TO EXIT EXTERNAL FREE EXIT PUSH LOOP DETECTOR BUTTON OR PRIMARY RELAY GATE OPERATOR EXIT COMMON 12 VDC POWER SUPPLY POSTAL LOCK** POSTAL LOCK NORMALLY OPEN COMMON GROUND DATA 0 DATA 1 REQUEST TO EXIT GROUND SUP NORMALLY OPEN COMMON NORMALLY OPEN COMMON NORMALLY CLOSED GROUND POWER POWER *AUXILIARY RELAY MAGLOCK Use 18-22 AWG For AC Power: Install a Siemens S10K30MOV (Metal Oxide Varistor) or equivalent NORMALLY CLOSED For DC Power: Install a 1N4005 diode or equivalent - COMMON + Power for Maglock (Not Provided) DO NOT use the power supply for the controller AUXILIARY RELAY Low Voltage Power Supply Isolation Relay LIGHT LOAD LINE NEUTRAL NOTE: DO NOT connect high voltage power to OR the CAPXS unit. ALARM BYPASS ETHERNET CONNECTION DO NOT INSTALL THE SYSTEM IN THE FAIL SECURE MODE UNLESS PERMITTED BY THE LOCAL AUTHORITY HAVING JURISDICTION. Doing so may cause interference with the operation of panic hardware. COMMON NORMALLY OPEN * NOTE: MAGLOCK and ALARM BYPASS not evaluated by UL. ** NOTE: For more information on how to wire in a postal lock, refer to the manual for accessory: CAPXSTKPL. 16