Magnavox 42MF439B User Manual - Page 9
Antenna Connection, Connection to Cable Receiver or Satellite Box - troubleshooting
UPC - 609585164000
View all Magnavox 42MF439B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
INTRODUCTION PREPARATION WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION PREPARATION No supplied cables are used in this connection: Please purchase the necessary cables at your local store. High Speed HDMI cable (also known as HDMI category 2 cable) is recommended for the better compatibility. Before you connect... Be sure your antenna or other device is connected properly before plugging in the AC power cord. 5 Antenna Connection Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit. e.g.) VHF / UHF antenna rear of this unit RF coaxial cable or cable TV signal * Once connections are completed, turn on the unit and begin initial setup. Channel scanning is necessary for the unit to memorize all available channels in your area. (Refer to "Initial Setup" on page 14.) Note: • If you have any question about the DTV's antenna, visit www.antennaweb.org for further information. • Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items. • For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit. • If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than settop versions. • To switch your reception source easily between antenna and cable, install an antenna selector. • If you connect to the cable system directly, contact the CATV installer. 5 Connection to Cable Receiver or Satellite Box Use an HDMI or an RCA component video cable to connect the HDMI or the component video input jack of the unit to the HDMI or the component video output jack of the cable receiver / satellite box. If you connect to the unit's COMPONENT video input jack, connect an RCA audio cable to the audio L/R jack of COMPONENT accordingly. e.g.) HDMI OUT HDMI cable satellite dish or ANT IN RF coaxial cable or AUDIO OUT L R COMPONENT VIDEO OUT Y Pb/Cb Pr/Cr (green) (blue) (red) cable TV signal including PPV S ER O CM cable receiver / satellite box * You can also connect this unit to the cable receiver or satellite box other than the HDMI or the component video output jack because they might have different output jacks. * Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear QAM may differ depending on the cable / satellite provider. For more information, please contact your cable / satellite provider. or (green) (blue) (red) side or rear of this unit RCA component video cable and RCA audio cable or 9 EN