NEC 20WMGX2 MultiSync 20WMG2 - Page 13

Installation Instructions continued Precautions when connecting the antenna • Use a coaxial cable which is free from interference. Avoid using a parallel flat wire as interference may occur, causing the reception to become unstable and noise to appear on the screen. • Avoid using an indoor antenna as this may be affected by interference and poor reception. • Keep the power cord as far away from the antenna wire as possible. • Auto Tuning please refer to page 24 VHF(300-Ohm) antenna / UHF antenna When using a 300-ohm twin lead from an outdoor antenna, connect the VHF or UHF antenna leads to the screws of the VHF or UHF adapter. Plug the 300-ohm to 75-ohm adapter into the antenna on the LCD MONITOR. When both VHF and UHF antennas are combined Attach an optional antenna cable signal combiner to the LCD MONITOR antenna terminal, and connect the cables to the antenna mixer. Consult your local electronics retailer about available signal combiners. Reconnect the unit to the power source and turn on the power. Using the Remote Control or User Controls, select the "CHANNEL SETTING MENU". Select the appropriate menu based upon which source (cable or antenna) is being used. Refer to pages 15 and 16 for further information on the "CHANNEL SETTING MENU" as well as for information on how to use the "AUTO SEARCH" function to program available channels. Tilt and Swivel Grasp both sides of the monitor screen with your hands and adjust the tilt and swivel as desired (Figure TS.1). NOTE: Handle with care when tilting and swiveling the monitor screen. MENU/EXIT SELECT/1-2 RESET/DV MODE Figure TS.1 11