NEC LCDMT600 User Manual - Page 14

1 INTRODUCTION This section introduces you to your new MultiSync MT600 LCD Projector, provides a list of materials that comes with your projector and describes the features and controls. Congratulations On Your Purchase Of TheMultiSync MT600 LCD Projector The MultiSync MT600 is one of the very best LCD projectors available today. The multiple LCD panels enable you to project precise images up to 300 inches across (measured diagonally) from your PC or Macintosh computer (desktop or notebook), VCR, document camera, or even a laser disc player. You can use the projector on a tabletop or cart, you can permanently mount it on a ceiling*, or you can use MultiSync MT600 LCD Projector to project images from behind the screen. The remote control can be used wirelessly or with a cable, and you can even use the remote control with the IR receiver to operate the mouse on your PC or Mac. But best of all, the MultiSync MT600 is an NEC LCD projector. That means you can depend on years of reliable performance and crystal-clear presentations! The features you'll enjoy include: • Simple set up and operation. • A high-performance 250 watt metal halide lamp that delivers 400 lumens (ANSI) and is guaranteed for 2000 hours of service or six months, whichever comes first. • The "High Contrast" mode creates a clear image from a document camera. • The power zoom control enables you to adjust the image to be between 20 and 300 inches (measured diagonally). • The "2X-4X" button allows you to double and quadruple the size of the image with a single click of the remote. • An image can be projected from in front or behind a screen, and the projector can even be installed on the ceiling. 13 Condition Blinking Rapidly (4 times a second) Status The projector is overheated. The lamp turns off automatically. Allow the fan to run at least two minutes before unplugging the projector. Then check the filter and clean it if necessary. If there is insufficient ventilation around the projector or if the room where you're presenting is particularly warm, move the projector to a cooler location. In either case, allow at least five minutes before turning the projector back on. If the problem persists, contact your NEC dealer for service. TROUBLESHOOTING 50