NEC LCDMT600 User Manual - Page 20

4. Left Channel/Mono Audio Input Jack This is your left channel audio input for stereo sound coming from video equipment or audio system. It also serves as the mono audio input for S-Video input. 5. Right Channel Audio Input Jack This is your right channel audio input for stereo sound. 6. Video Input Connect a VCR or laser disk player here to project the video. 7. RGB-Input/Through-Put Connectors Attach either end of the MultiCable to computer or document camera, and then attach the other end to either of these two connectors. You can then use the remaining connector, if you wish, to output the video signal to a monitor. (If you do use a second monitor, turn the monitor switch REMOTE PC S-VIDEO L/MONO R CONTROL CONTROL INPUT VIDEO INPUT 1 2 AUDIO INPUT VIDEO 3 45 6 External Monitor On/Off RGB THROUGHPUT RGB 8 7 CAUTION • Only clean the outside of the filter with a vacuum cleaner. • Do not clean inside the projector where the filter is positioned and the caution label is placed. • Do not attempt to operate the projector without a filter. • Your LCD projector will not operate unless the filter is installed correctly. • Do not put the LCD projector on end except for lamp and/or air filter replacemant. Remote Control Battery Installation 1. Press firmly on point "A" and slide the battery cover off. 2. Remove all four old batteries and install new ones (AAA). Ensure that you have the batteries' polarity (+/-) aligned correctly. 3. Slip the cover back over the batteries until it snaps into place. - + AUDIO AUDIO DC12V/400mA INPUT OUTPUT OUTPUT 9 0A 19 A MAINTENANCE 44