NEC X552S Users Manual - Page 28

LAN SETTING When you use this function, EXTERNAL CONTROL should be "LAN". NOTE: When changing the LAN SETTING, you need to wait several seconds until the LAN SETTING is applied. DHCP Enabling this option automatically assigns an IP address to the monitor from your DHCP server. Disabling this option allows you to register the IP address or subnet mask number obtained from your network administrator. NOTE: Consult your network administrator for the IP address when "ENABLE" is selected for [DHCP]. DISABLE IP ADDRESS Set your IP address of the network connected to the monitor when "DISABLE" is selected for [DHCP]. 192.168.0.10 SUBNET MASK Set your subnet mask number of the network connected to the monitor when "DISABLE" is selected for [DHCP]. 255.255.255.0 DEFAULT GATEWAY Set your default gateway of the network connected to the monitor when "DISABLE" is selected for [DHCP]. 192.168.0.1 DNS PRIMARY Set your primary DNS settings of the network connected to the monitor. 0.0.0.0 DNS SECONDARY Set your secondary DNS settings of the network connected to the monitor. 0.0.0.0 SETTING COPY In a daisy chain scenario, select the OSD menu categories that you want to copy over to the NO other monitor. NOTE: When you use this function, EXTERNAL CONTROL should be "RS-232C". This function resets to default when power is off. This function has a limit depending on the cable you use. COPY START Select "YES" and press the SET button to start copying. ALL INPUT All input terminals settings are copied when you select this item. Default is off. RESET Resets "MULTI DISPLAY" options back to factory settings except LAN SETTING and TILE - MATRIX MEM. DISPLAY PROTECTION POWER SAVE Sets how long the monitor waits to go into power save mode after the signal is lost. ON Note: When connecting DVI, the video card might not stop sending the digital data even though the image might have disappeared. If this occurs the monitor will not switch into power management mode. HEAT STATUS Displays status of the FAN, BACKLIGHT and TEMPERATURE. - FAN CONTROL Cooling fan reduces the temperature of the display to protect from overheating. If "AUTO" is selected, you can adjust the start temperature of the cooling fan and fan speed. AUTO SCREEN SAVER Use the SCREEN SAVER function to reduce the risk of Image Persistence. GAMMA The display gamma is changed and fixed when "ON" is selected. OFF BACKLIGHT The brightness of backlight is decreased when "ON" is selected. NOTE: Do not select this function when picture mode is AMBIENT1 or AMBIENT2. OFF MOTION The screen image is slightly expanded and moves in 4 directions (UP, DOWN, RIGHT, LEFT) at user determined intervals. You can set interval time and zooming ratio. This function is disabled when PIP, STILL, TEXT TICKER or TILE MATRIX are enabled. OFF SIDE BORDER COLOR Adjusts the color of the side borders when a 4:3 image is displayed. 15 Press + button, the bar will become lighter. Press - button, the bar will become darker. AUTO BRIGHTNESS DPORT, DVI, VGA inputs only Adjusts the brightness level according to the input signal. NOTE: Do not select this function when picture mode is AMBIENT1 or AMBIENT2. OFF CHANGE SECURITY Allows the security password to be changed. - PASSWORD The factory preset password is 0000. SECURITY Locks the security password. OFF DDC/CI ENABLE/DISABLE: Turns ON or OFF the two way communication and control of the monitor. ENABLE ALERT MAIL Selects whether or not to send an e-mail notification of monitor error via wired LAN. OFF RESET Resets the following settings within the DISPLAY PROTECTION menu back to factory - setting: POWER SAVE, FAN CONTROL, SCREEN SAVER, SIDE BORDER COLOR, AUTO BRIGHTNESS, DDC/CI. English-26