NEC X552S Users Manual - Page 7
Installation, Mounting, Please note the following when mounting, on wall or ceiling - weight
View all NEC X552S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
English Installation This device cannot be used or installed without the Tabletop Stand or other mounting accessory for support. For proper installation it is strongly recommended to use a trained, NEC authorized service person. Failure to follow NEC standard mounting procedures could result in damage to the equipment or injury to the user or installer. Product warranty does not cover damage caused by improper installation. Failure to follow these recommendations could result in voiding the warranty. Mounting DO NOT mount the monitor yourself. Please ask dealer. For proper installation it is strongly recommended to use a trained, qualified technician. Please inspect the location where the unit is to be mounted. Mounting on wall or ceiling is the customer's responsibility. Not all walls or ceilings are capable of supporting the weight of the unit. Product warranty does not cover damage caused by improper installation, remodelling, or natural disasters. Failure to comply with these recommendations could result in voiding the warranty. DO NOT block ventilated openings with mounting accessories or other accessories. For NEC Qualified Personnel: To ensure safe installation, use two or more brackets to mount the unit. Mount the unit to at least two points on the installation location. Please note the following when mounting on wall or ceiling • When using mounting accessories other than those that are NEC approved, they must comply with the VESAcompatible (FDMlv1) mounting method. • NEC strongly recommends using size M6 screws Unit No gap Mounting Bracket (10-12 mm + thickness No thread Washers of bracket and washers in 4 mm length). If using screws under 8.5 mm Screw longer than 10-12 mm, check the depth of the hole. 10-12 mm Thickness (Recommended Fasten of bracket Force: 470 - 635N•cm) and washers Screw length should equal NEC recommends mounting depth of hole (10-12 mm) + the interfaces that comply with thickness of mounting bracket UL1678 standard in North and washers. Bracket hole America. should be under 8.5 mm. • Prior to mounting, inspect the installation location to insure that it is strong enough to support the weight of the unit so that the unit will be safe from harm. • Refer to the instructions included with the mounting equipment for detailed information. • Make sure there is no gap between the monitor and the bracket. Using an optional wall mount • When using an optional wall mount, stand holders may need to be taken out. See diagram below: Optional Stand holder If mounting accessory is interfered with stand holder, it may need to be taken out also. • When using an optional wall mount (WM-46S-L/ WM-46S-P)* or there is not enough room in back side, the handles may need to be changed from normal to thin position. See diagram below: *: Except for X401S (X401S) Normal position Thin position (X462S/X552S) Screw position change Normal position Thin position English-5