Netgear FS726T FS726T User Manual - Page 19

Switch> Port Configuration: Set speed, Switch> Statistics - web

Get Netgear FS726T - ProSafe Smart Switch PDF manuals and user guides
UPC - 606449038415
View all Netgear FS726T manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

Smart Switch Series Software Manual • Flow Control: Indicates whether Flow Control support is set for on (Enabled) or off (Disabled). The default setting for all ports is enabled. • Link Status: Indicates the current speed and duplex for the port. DOWN means no link. Switch> Port Configuration: Set speed • Click a port ID. • Click to select a speed from the pull-down menu under Speed. • Click Apply to activate the new speed. Note: Please be aware that speed must set as same as link partner. Otherwise, packet loss or link error might occur. Switch> Port Configuration: Set flow control • Click a port ID. • Click to select Enable or Disable from the pull-down menu under Flow Control. • Click Apply to activate the new setting. Switch> Statistics Page The Statistics Table shows the statistics types for one port over time. • ID: The port number on the switch • Tx: Transmitted packet/s. • Rx: Received packet/s. Web-Based Management Interface 4-5 July 2005

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
Smart Switch Series Software Manual
Web-Based Management Interface
4-5
July 2005
•
Flow Control: Indicates whether Flow Control support is set for on (Enabled) or off
(Disabled). The default setting for all ports is enabled.
•
Link Status: Indicates the current speed and duplex for the port. DOWN means no link.
Switch> Port Configuration: Set speed
•
Click a port ID.
•
Click to select a speed from the pull-down menu under Speed.
•
Click Apply to activate the new speed.
Note:
Please be aware that speed must set as same as link partner. Otherwise, packet loss or link
error might occur.
Switch> Port Configuration: Set flow control
•
Click a port ID.
•
Click to select Enable or Disable from the pull-down menu under Flow Control.
•
Click Apply to activate the new setting.
Switch> Statistics Page
The Statistics Table shows the statistics types for one port over time.
•
ID: The port number on the switch
•
Tx: Transmitted packet/s.
•
Rx: Received packet/s.