Netgear FSM7326P FSM7326P User Manual - Page 76
config network mactype, config network protocol
UPC - 606449031072
View all Netgear FSM7326P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software • Bit 7 of byte 0 (called the I/G bit) indicates whether the destination address is an individual address (b'0') or a group address (b'1'). • The second character, of the twelve character macAddr, must be 2, 6, A or E. A locally administered address must have bit 6 On (b'1') and bit 7 Off (b'0'). Format config network macaddr config network mactype This command specifies whether the burnedin MAC address or the locally-administered MAC address is used. Default Format burnedin config network mactype config network parms This command sets the IP Address, subnet mask and gateway of the router. The IP Address and the gateway must be on the same subnet. Format config network parms [gateway] config network protocol This command specifies the network configuration protocol to be used. If you modify this value change is effective immediately. See "save config" on page 74 for more information. Default Format none config network protocol , where bootp indicates that the switch periodically sends requests to a Bootstrap Protocol (BootP) server or a dhcp server until a response is received. none indicates that the switch should be manually configured with IP information. config network webmode This command enables or disables access to the switch through the Web interface. When access is enabled, the user can login to the switch from the Web interface. When access is disabled, the user cannot login to the switch's Web server. Disabling the Web interface takes effect immediately. All interfaces are effected. 7-14 202-10009-01 Switching Commands