Netgear PS101 Reference Manual - Page 25
TCP/IP - default ip
UPC - 606449023442
View all Netgear PS101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
NetGear Print Server Manual TCP/IP The TCP/IP configuration screen is used to configure the IP address of the print server. Figure 3-3 shows the TCP/IP configuration screen and following table lists its fields, describes the functions, and explains how to provide information in each field. Figure 3-3 TCP/IP Configuration Screen TCP/IP Configuration Fields This field allows you to enable or disable the print server's ability to get its IP address from a DHCP DHCP Client (Dynamic Host Configuration Protocol) server. When disabled, you can provide a fixed IP address in the following fields. If DHCP client is enabled, the fields that follow are not used. IP Address This IP address is assigned to the print server. If you have a private LAN and do not plan to connect to the TCP/IP based internet, NETGEAR recommends that you use the address from the IETF-designated private addresses (for example, 192.168.x.x or 10.x.x.x). Subnet Mask This subnet mask defines the range of addresses that are reachable on your local LAN. For example, in a network with a NETGEAR router, the default subnet mask is usually 255.255.255.0. Gateway Address This is the IP address of the router on your network. For example, in a network with a NETGEAR router, the gateway address is usually 192.168.0.1. Save Cancel Buttons Save: After the configuration, click on 'Save' button to save the value permanently to Print Server. Cancel: If changed something that is not good, click on 'Cancel' button will load the value back from the print server. No modification will be made. 16