NordicTrack E 7.1 Elliptical English Manual - Page 13

Attach the Front Upright Cover 24 around - parts

Get NordicTrack E 7.1 Elliptical PDF manuals and user guides View all NordicTrack E 7.1 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

14. Attach the lower end of the Console (33) to the Upright (5) with two M4 x 19mm Screws (156). 14 See step 12 on page 12. Tighten the M4 x 19mm Screws (156) in the upper end of the Console (33). 15. Orient the Front Upright Cover (24) as shown. 15 Attach the Front Upright Cover (24) around the Upright (5) by pressing the tabs on the Front Upright Cover into the Rear Upright Cover (25). 33 156 5 156 24 25 5 16. Make sure that all parts of the elliptical are properly tightened. Note: An extra grease packet and some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
13
16.
Make sure that all parts of the elliptical are properly tightened.
Note: An extra grease packet and some
hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a
mat under the elliptical.
24
25
15. Orient the Front Upright Cover (24) as shown.
Attach the Front Upright Cover (24) around the
Upright (5) by pressing the tabs on the Front
Upright Cover into the Rear Upright Cover (25).
14. Attach the lower end of the Console (33) to the
Upright (5) with two M4 x 19mm Screws (156).
See step 12 on page 12. Tighten the M4 x
19mm Screws (156) in the upper end of the
Console (33).
5
33
5
156
156
14
15