NordicTrack E 7.1 Elliptical English Manual - Page 23
Loosen the Pivot Screw 97. Tighten the Belt - e 7 2 1 elliptical head
View all NordicTrack E 7.1 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
HOW TO ADJUST THE DRIVE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, first unplug the power cord. Using a flat screwdriver, release the tabs on the Access Cover (20) and pry the Access Cover upward off the elliptical. Loosen the Pivot Screw (97). Tighten the Belt Adjustment Screw (85) until the Drive Belt (38) is tight. When the Drive Belt is tight, tighten the Pivot Screw. 38 97 85 13 46 50 153 20 19, 18 When you are finished, reattach the left shield, replace the left pedal arm, and reattach the access cover. Then, plug in the power cord. Next, lift the Latch (50) on the underside of the Left Pedal Arm (13), and then lift the Left Pedal Arm off the left Pedal Arm Sleeve (46). See EXPLODED DRAWING C on page 31. Remove the M4 x 16mm Round Head Screws (152) and the M4 x 42mm Screws (153) from the Right and Left Shields (18, 19). (Note: Make sure to note which size Screws come from which holes.) Then, carefully remove the Left Shield. 23