NordicTrack E400 Instruction Manual - Page 12

13. While a second person holds the Console (47) near the Upright (4), plug the Upper Wire (50) 13 and the Pulse Wires (55) into the receptacles on the Console. The connectors on the Upper Wire (50) and the Pulse Wires (55) should slide easily into the receptacles and snap into place. If a connector does not slide easily into a receptacle, turn the connector and try again. If you do not connect the connectors properly, the Console (47) may become damaged when you use the elliptical. Insert the excess wires into the Upright (4). Tip: Avoid pinching the wires. Attach the Console (47) to the Upright (4) with four M4 x 10mm Screws (52) and four M4 Washers (106); start all the Screws, and then tighten them. 47 Avoid pinching the wires 55 4 50 106 106 52 52 14. Identify the Right Arm Front and Rear Covers (42, 102), and orient them as shown. Press the Right Arm Front and Rear Covers (42, 102) together around the right Upper Body Leg (7). Then, attach them with two M3 x 10mm Screws (41). Attach the Left Arm Rear and Front Covers (88, 103) to the left Upper Body Leg (7) in the same way. 14 88 103 7 102 41 42 7 12