NordicTrack Ebu Nt 9600 Bike Canadian English Manual - Page 19

Follow your progress with the main display., When you are finished using the upright bike,

Get NordicTrack Ebu Nt 9600 Bike PDF manuals and user guides View all NordicTrack Ebu Nt 9600 Bike manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

During the program, you can change the resistance of the pedals, if desired, by pressing the RESISTANCE + and - buttons or the QUICK RESISTANCE buttons. However, when the current segment ends, the resistance will automatically increase or decrease, if needed, to bring your heart rate closer to the target heart rate setting for the next segment. Note: Each pulse program begins with a two-minute warm-up period and ends with a two-minute cool-down period. During these periods, the resistance level cannot be changed. If your pulse is not detected during the program, the letters "PLS" will flash in the main display, and the resistance of the pedals may automatically decrease. If this occurs, see the instructions included with your chest pulse sensor. 7 Follow your progress with the main display. See step 5 on page 10. 8 When you are finished using the upright bike, the console will automatically enter an idle mode or turn off. See step 7 on page 11. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
18
During the program, you can change the resis-
tance of the pedals, if desired, by pressing the
RESISTANCE + and – buttons or the QUICK RE-
SISTANCE buttons. However, when the current
segment ends, the resistance will automatically in-
crease or decrease, if needed, to bring your heart
rate closer to the target heart rate setting for the
next segment. Note: Each pulse program begins
with a two-minute warm-up period and ends with a
two-minute cool-down period. During these peri-
ods, the resistance level cannot be changed.
If your pulse is not detected during the program,
the letters “PLS” will flash in the main display, and
the resistance of the pedals may automatically de-
crease. If this occurs, see the instructions included
with your chest pulse sensor.
Follow your progress with the main display.
See step 5 on page 10.
When you are finished using the upright bike,
the console will automatically enter an idle
mode or turn off.
See step 7 on page 11.
8
7