NordicTrack Ex3600 User Manual - Page 7

76)-4 1" Tek Screw (82)-4 t (77)-2 ASSEMBLY 3/4" Tek Screw (58)-8 1/2" Screw (10)-3 Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included hex key and your own phillips screwdriver . For help identifying assembly hardware, see the drawings below. Note: If a part is not found in the part bags, check to see if the part has been preattached. To avoid damaging plastic parts, do not use power tools for assembly. Upright Star Washer (71)-6 Handrail Star Washer (90)-6 Handrail Bolt (64)-6 Washer (78)-6 3/4" Screw (4)-2 Upright Bolt (72)-6 1. Identify the Right Upright (74), which is marked with a sticker. Place the Right Upright near the right side of the treadmill. Next, identify the lower end of the Right Upright, which has three small holes. Feed the Upright Wire (75) into the lower end of the Right Upright and out of the upper end as shown. See the inset drawing. Place the Left Upright (73) near the left side of the treadmill. Feed the TV Cable (110) into the lower end of the Left Upright and out of the upper end as shown. Stretch the included elastic bands around the upper ends of the Uprights (73, 74) to hold the TV Cable (110) and the Upright Wire (75). Do not remove the elastic bands until you begin step 6. 1 Band 75 74 Small Holes 73 110 Band 7