NordicTrack Ex3600 User Manual - Page 8

2. Insert the Right Upright (74) into the indicated bracket on the Base (83); be careful not to dislodge the Cage Nuts (76 [see the inset drawing]) from the Right Upright; in addition, be careful not to pinch the Upright Wire (75). Finger tighten three Upright Bolts (72) with three Washers (78) and three Upright Star Washers (71) into the bracket and the Right Upright. Do not tighten the Upright Bolts yet. Repeat this step with the Left Upright (73). 2 73 75 78 72 76 74 78 71 72 83 71 Bracket 3. Attach the Catch (5) to the left side of the Frame (48) with 3 two 3/4" Screws (4). With the help of a second person, raise the Frame (48) to a vertical position. Be careful not to raise the Frame past the vertical position. Have the other person hold the Frame until step 5 is completed. Left side of Treadmill 4 5 48 4. Hold the cylinder end of the Gas Spring (88) near the bracket in the center of the Frame (48). See the two small inset drawings. Using your fingernail or the end of a screwdriver, press on the end of the Spring Pin (102) to loosen it from the Gas Spring (88). Next, rotate the Spring Pin and pull it out of the Shock. Be careful to avoid losing the Spring Pin. Orient the Gas Spring (88) so it is in the position shown. Press the end of the Gas Spring onto the ball on the bracket. See drawing 4a. Insert the Spring Pin (102) into the two indicated small holes in the end of the Gas Spring (88). Then, rotate the Spring Pin until it clips onto the Shock. Note: Extra Spring Pins are included. 4 Cylinder 102 88 48 Bracket 102 102 4a 88 102 Hole Hole Bracket 8