NordicTrack T17.2 Uk Manual - Page 15

17. S lide the Handrail Covers (79, 80) forward until they match up with the Console Base (64). Attach the Handrail Covers with the four #8 x 1 1/4" Screws (107) that you removed in steps 10 and 11. Do not overtighten the Screws. 17 Console Assembly Tighten four #8 x 3/4" Screws (2) into the console assembly in the locations shown. Note: Some of the #8 x 3/4" Screws (2) are designed to go in at different angles. 79 107 2 Raise the Base Covers (82, 83) and firmly tighten the four 3/8" x 2 3/4" Screws (7) first and then the 3/8" x 1 1/4" Screws (8) (only one side is shown). Then, press the Base Covers into 82 place. 64 2 80 107 83 7 8 18. Raise the Frame (56) to the position shown. 18 Orient the Storage Latch (53) so that the large barrel and the latch knob are oriented as shown. Attach the lower end of the Storage Latch (53) to the Base (94) with a 3/8" x 2" Bolt (3) and a 3/8" Nut (12). Attach the upper end of the Storage Latch (53) to the Frame (56) with a 3/8" x 2" Bolt (3) and a 3/8" Nut (12). Lower the Frame (56) (see HOW TO LOWER THE TREADMILL FOR USE on page 25). 56 12 3 Latch Knob 53 Large Barrel 94 12 3 19. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. Note: Extra parts may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 27 and 28). 15