Oki C710n C710 User's Guide, English - Page 85
Replacing the Transfer Belt Unit, Switch off the printer and allow the fuser to cool for about
View all Oki C710n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
10. Holding the complete assembly by its top centre, lower it into place in the printer, locating the pegs at each end into their slots in the sides of the printer cavity. 11. Finally, close the top cover and press down firmly at both sides so that the cover latches closed. Note: If you need to return or transport your printer for any reason, please make sure you remove the image drum unit beforehand and place in the bag provided. This is to avoid toner spillage. Replacing the Transfer Belt Unit ____ The belt unit is located under the four image drums. This unit requires replacement approximately every 60,000 pages. Switch off the printer and allow the fuser to cool for about 10 minutes before opening the cover. 85 - C710n User's Guide
85
– C710n User’s Guide
10.
Holding the complete assembly by its top centre, lower it into
place in the printer, locating the pegs at each end into their
slots in the sides of the printer cavity.
11.
Finally, close the top cover and press down firmly at both
sides so that the cover latches closed.
Replacing the Transfer Belt Unit ____
The belt unit is located under the four image drums. This unit
requires replacement approximately every 60,000 pages.
Switch off the printer and allow the fuser to cool for about
10 minutes before opening the cover.
Note:
If you need to return or transport your printer for any
reason, please make sure you remove the image drum
unit beforehand and place in the bag provided. This is to
avoid toner spillage.