Onkyo A-9150 Owners Manual - English - Page 26

Connecting with Onkyo RI Components By connecting an Onkyo component with jack to the unit by using an cable and a digital cable or an RCA cable, you can link the unit's power and input selection and enable operation with this unit's remote controller (*). After connecting the unit and the Onkyo component with a digital cable or RCA cable (Ä page 15 to 17), perform the following operations. 4 Press B/A on the remote controller to select the jack to use for linking. The flashing of the input source LEDs changes each time you change the setting. 1 When linking with a CD player When connected to the D1 jack, make it so only the "D1" LED is flashing (the default value is "D1"). When connected to the LINE 1 jack, make it so only the "LINE 1" LED is flashing. 1 When linking with a tuner When connected to the D2 jack, make it so only the "D2" LED is flashing (the default value is "D2"). When connected to the LINE 2 jack, make it so only the "LINE 2" LED is flashing. 1 When linking with a dock or network audio player When connected to the D3 jack, make it so only the "D3" LED is flashing (the default value is "D3"). When connected to the LINE 3 jack, make it so only the "LINE 3" LED is flashing. 5 Press SETUP on the remote controller. D/C/B/A CD Player SETUP 1 Connect the cable. When there are two jacks, both jacks work in the same way. You can connect either one. 2 Press SETUP on the remote controller. SETUP does not work when MAIN IN input is selected. Select an input other than MAIN IN to operate. 3 Repeatedly press D/C on the remote controller. 1 When linking with a CD player Select so that D1 and LINE 1 light (or flash). 1 When linking with a tuner Select so that D2 and LINE 2 light (or flash). 1 When linking with a dock or network audio player Select so that D3 and LINE 3 light (or flash). En 26 A connection to the jack is not enough for the units to operate as a system. The units must also be connect properly by a digital cable or an RCA cable. Refer to "Remote Controller" (Ä page 10) for operation of connected devices. Note • cables can be connected in any order. • Some functions may not be supported depending on the product even when an connection is used. • The feature on this unit supports Onkyo CD players, tuners, network audio players, and docks only. It does not work properly with other devices such as MD recorders. • Only auto-power on and direct change are supported for CD players. • Refer to the instruction manual of the component with the jack for details. * With (Remote Interactive), you can use the following special functions: ∫ Auto Power On When you start playback on a component connected via while the integrated amplifier is on Standby, the integrated amplifier will automatically turn on and select that component as the input source. ∫ Direct Change When playback is started on a component connected via , the integrated amplifier automatically selects that component as the input source. ∫ System Off When you turn off the integrated amplifier, the components turn off automatically.