Onkyo A-9150 Owners Manual - English - Page 7

Before Using the Integrated Amplifier Installing the Batteries 1 To open the battery compartment, press the small hollow and slide the cover. Using the Remote Controller To use the remote controller, point it at the integrated amplifier's remote control sensor, as shown below. Remote control sensor Integrated amplifier 2 Insert the two supplied batteries (R03/AAA) in accordance with the polarity diagram inside the battery compartment. 3 Replace the cover and slide it shut. Approx. 16 ft. (5 m) Note • The remote controller may not work reliably if the integrated amplifier is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing. • If another remote controller of the same type is used in the same room, or the integrated amplifier is installed close to equipment that uses infrared rays, the remote controller may not work reliably. • Don't put anything, such as a book, on the remote controller, because the buttons may be pressed inadvertently, thereby draining the batteries. • The remote controller may not work reliably if the integrated amplifier is installed in a rack behind colored glass doors. Keep this in mind when installing. • The remote controller will not work if there's an obstacle between it and the integrated amplifier's remote control sensor. Installing the Integrated Amplifier Note • If the remote controller doesn't work reliably, try replacing the batteries. • Don't mix new and old batteries or different types of batteries. • If you intend not to use the remote controller for a long time, remove the batteries to prevent damage from leakage or corrosion. • Remove expired batteries as soon as possible to prevent damage from leakage or corrosion. Approx. 8 in. (20 cm) Ensure proper ventilation. Approx. 4 in. (10 cm) Approx. 8 in. (20 cm) Approx. 8 in. (20 cm) Install the integrated amplifier on a sturdy rack or shelf. Position it so that its weight is evenly dispersed on its four legs. Do not install the integrated amplifier in a place with vibration or an unstable location. The integrated amplifier is designed to have high conversion efficiency, however, its temperature will become much higher than other audio equipment. Therefore, make sure not to hamper heat dissipation by ensuring proper ventilation. En 7