Onkyo TX-8390 User Manual English - Page 93
Power Management
View all Onkyo TX-8390 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Contents ≫ Connections ≫ Playback ≫ Setup ≫ Setting Item Pairing Information Device Status Default Value - - Setting Details You can initialize the pairing information stored on this unit. Pressing ENTER when "Clear" is displayed initializes the pairing information stored on this unit. • This function does not initialize the pairing information on the BLUETOOTH-enabled device. When pairing the unit again with the device, be sure to clear the pairing information on the BLUETOOTH-enabled device beforehand. For information on how to clear the pairing information, refer to the instruction manual of the BLUETOOTH-enabled device. Displays the name of the BLUETOOTH-enabled device connected to the unit. • The name is not displayed when "Status" is "Ready" and "Pairing". Displays the status of the BLUETOOTH-enabled device connected to the unit. "Ready": Not paired "Pairing": Paired "Connected": Successfully connected • Wait for a while if "Bluetooth" cannot be selected. It can be selected when the BLUETOOTH function is activated. 4. Power Management Change the settings for the power-save function. Setting Item Sleep Timer Default Value Off Setting Details You can allow the unit to enter standby automatically when the specified time has elapsed. Select a value from "30 minutes", "60 minutes" and "90 minutes". "Off": The unit does not automatically enter standby mode. Setting Item Auto Standby Auto Standby in HDMI Standby Through USB Power Out at Standby Default Value On/Off On/Off Off Setting Details This setting allows the unit to enter standby mode automatically after 20 minutes of inactivity without any video or audio input. (When "USB Power Out at Standby" or "Network Standby" is enabled, the unit enters the HYBRID STANDBY mode which minimizes the increase in power consumption.) "On": The unit automatically enters standby mode ("AUTO STBY" lights up). "Off": The unit does not automatically enter standby mode. • "Auto Standby" is displayed on the main unit's display and TV screen 30 seconds before entering standby mode. • "Auto Standby" does not work when Zone 2 is active. • Default values vary depending on the regions. Enable or disable "Auto Standby" while "HDMI Standby Through" is on. "On": The setting is enabled. "Off": The setting is disabled. • This setting cannot be set to "On" if "Auto Standby" and "HDMI Standby Through" are set to "Off". • Default values vary depending on the regions. When this function is set to "On", electricity can be supplied to the device connected to the USB port on the rear panel even if this unit is in standby mode . The USB port on the front panel does not support power supply to a connected USB device when the unit is in standby mode. • When this function is set to "On", the power consumption in standby state increases, however, the increase in power consumption is minimized by automatically entering the HYBRID STANDBY mode where only the essential circuits operate. 93 Front Panel≫ Rear Panel≫ Remote≫