Onkyo TX-L50 User Manual English - Page 19
Before Start, Part Names, > Install, > Playback - review
View all Onkyo TX-L50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
> Before Start > Part Names > Install > Initial Setup > Playback Supplementary Information | Advanced Setup | Others 1. AccuEQ Room Calibration Place the supplied speaker setup microphone in the listening position, measure the test tones emitted by the 0 To cancel AccuEQ Room Calibration partway through, disconnect the speaker setup microphone. 2. Select the connected speaker configuration. AccuEQ Room Calibration Review Crossover E N Subwoofer : Yes speakers, then the unit automatically sets the optimum Front : 100Hz volume level for each speaker, the crossover frequencies, AccuEQ Room Calibration Center Surround : 100Hz : 100Hz and the distance from the listening position. This also Speaker Channels 2.1 ch < > automatically adjusts the equalizers for the speakers and Subwoofer Yes Save enables correction of distortion caused by the acoustic Height Speaker --- Cancel environment of the room. 0 Calibration takes between 3 to 12 minutes to be completed. The speakers emit the test tone at high Select how many speakers you have. Next 6. Select whether to enable or disable the equalizer function that corrects for distortion caused by the acoustic volume during measurement, so be careful of your environment of the room. surroundings. Keep the room as quiet as possible during The image on the screen changes as you choose the measurement. 0 If the power of this unit suddenly turns off, the wires in the number of channels in "Speaker Channels", so refer to it when performing the settings. Also use this screen to AccuEQ Room Calibration speaker cables may have touch the rear panel or other wires and tripped the protection circuit. Twist the wires select whether you have connected a subwoofer. 0 If you have connected a subwoofer, check the power To enable equalizer for each speakers, select "On". Please select "All Channels", if you have same speakers for all channels. Please select "Except Front Left / Right", if front speakers are larger than other speakers. again properly and make sure they do not stick out of the and volume of the subwoofer. The low frequencies speaker terminals when connecting. played by the subwoofer may not be discernible, so On (All Channels) On (Except Front Left / Right) 1. Place the supplied speaker setup microphone in the listening position, and connect to the SETUP MIC jack on the main unit. set its volume to at least halfway. 3. Test tones are emitted by the speakers, and firstly the unit detects the speakers connected and the noise in the environment. 4. After the results of the above measurements are displayed, select "Next", press ENTER on the remote controller, and the test tones are emitted again, and the unit automatically makes settings such as the optimum volume level and the crossover frequency. Off Next If this is to be enabled, then normally you should select "On (All Channels)", and to disable just the front speakers you should select "On (Except Front Left / Right)". 7. Disconnect the speaker setup microphone.You cannot use any other menu options while it is connected. 5. When the measurement is completed, the measurement SETUP MIC result is displayed. Press the cursors W/X on the remote controller to check the settings. Press ENTER when "Save" is selected to save the settings. 2. Source Connection Check that each input source is connected correctly. Follow the guidance, select the input you want to confirm, start play of the selected player, and confirm that the images appear on the TV and that sound is played. When putting the speaker setup microphone on a tripod, refer to the illustration when putting it in place. 19