Onkyo TX-L50 User Manual English - Page 57
Distance
View all Onkyo TX-L50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
> Before Start > Part Names > Install > Initial Setup > Playback Supplementary Information | Advanced Setup | Others Center Height Surround LPF of LFE Select the crossover frequency from "40Hz" to "200Hz" to start outputting frequencies for each channel. (Default Value is "100Hz") "Full Band": Full band will be output. 0 "Full Band" can be selected only when "Front" is set to "Full Band". 0 If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. Select the crossover frequency from "40Hz" to "200Hz" to start outputting frequencies for each channel. (Default Value is "100Hz") "Full Band": Full band will be output. 0 "Full Band" can be selected only when "Front" is set to "Full Band". 0 If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. Select the crossover frequency from "40Hz" to "200Hz" to start outputting frequencies for each channel. (Default Value is "100Hz") "Full Band": Full band will be output. 0 "Full Band" can be selected only when "Front" is set to "Full Band". 0 If an item cannot be selected even though connection is correct, check that the settings in "Configuration" - "Speaker Channels" matches the number of connected channels. Set the low-pass filter for LFE (low-frequency effect) signals in order to pass lower frequency signals than the set value and thus cancel unwanted noises. The low-pass filter will be effective only on sources with LFE channel. The value from "80Hz" to "120Hz (Default Value)" can be set. "Off": Do not use this function Double Bass This can be selected only when "Configuration" - "Subwoofer" is E set to "Yes" and "Front" is set to "Full Band". N Boost bass output by feeding bass sounds from the front left and right, and center speakers to the subwoofer. "On": Bass output will be boosted "Off": Bass output will not be boosted 0 The setting will not automatically be configured even if you performed AccuEQ Room Calibration. ˙ 3. Distance Set the distance from each speaker to the listening position. Front Left Center Front Right Height Left Height Right Surround Right Surround Left Subwoofer Specify the distance between each speaker and the listening position. (Default Value is "12.0ft/3.60m") Specify the distance between each speaker and the listening position. (Default Value is "12.0ft/3.60m") Specify the distance between each speaker and the listening position. (Default Value is "12.0ft/3.60m") Specify the distance between each speaker and the listening position. (Default Value is "9.0ft/2.70m") Specify the distance between each speaker and the listening position. (Default Value is "9.0ft/2.70m") Specify the distance between each speaker and the listening position. (Default Value is "7.0ft/2.10m") Specify the distance between each speaker and the listening position. (Default Value is "7.0ft/2.10m") Specify the distance between each speaker and the listening position. (Default Value is "12.0ft/3.60m") 0 Default values vary depending on the regions. 0 Distance units can be switched by pressing MODE on the remote controller. When the unit is set as feet, you can set between 0.1 ft and 30.0 ft in increments of 0.1 ft. When the unit is set as meters, you can set between 0.03 m and 9.00 m in increments of 0.03 m. 57