Onkyo TX-L50 User Manual English - Page 59

> Before Start > Part Names > Install > Initial Setup > Playback Supplementary Information | Advanced Setup | Others Surround After selecting the speaker frequency from between "25 Hz" and 3. Audio Adjust E "16 kHz" with the cursors W/X, adjust the volume of that frequency between "j6.0 dB" and "i6.0 dB" with S/T. (Default ˙ 1. Multiplex/Mono N Value is "0.0 dB") Multiplex Input Set the audio channel or language to be output when playing Subwoofer After selecting the speaker frequency from between "25 Hz" and "160 Hz" with the cursors W/X, adjust the volume of that frequency between "j6.0 dB" and "i6.0 dB" with S/T. (Default Value is "0.0 dB") 0 This cannot be selected if "No" is set in "Configuration" "Subwoofer". Channel multiplex audio or multilingual TV broadcasts etc. "Main (Default Value)": Main channel only "Sub": Sub channel only "Main / Sub": Main and sub channels will be output at the same time. 0 If multiplex audio is being played, "1+1" will be displayed on the display of this unit when on the remote controller is 0 The result may not be as expected depending on the input source and listening mode pressed. setting. Mono Input Channel Set the input channel to use for playing any 2 ch digital source such as Dolby Digital, or 2 ch analog/PCM source in the Mono listening mode. "Left": Left channel only "Right": Right channel only "Left + Right (Default Value)": Left and right channels ˙ 2. Dolby Loudness Management When playing Dolby TrueHD, enable the dialog normalization function which keeps the volume of dialog at a certain level. Note that when this setting is Off, the Late Night function that allows you to enjoy surround at low volumes is fixed to off when playing Dolby Digital Plus/Dolby TrueHD. "On (Default Value)": Use this function "Off": Do not use this function 59