Panasonic AW-HS50 Basic Operating Instructions - Page 33
Supplied AC adapter, AC 100 V to 240 V, 1.3 A, 47 Hz to 63 Hz
View all Panasonic AW-HS50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
4. Specifications Control I/O Other LAN (RJ-45) 10BASE-T/100BASE-TX (For IP control) Connecting cable: LAN cable (category 5 or above), max. 100 m [328 ft.], STP (Shielded Twisted Pair) cable recommended When connecting to a hub (switching hub), use a straight cable. Use a crossover cable when connecting the unit and another device on a 1:1 basis without going through a hub. TALLY/GPI (D-sub 15-pin, female, inch thread) INPUT : 5 inputs, photocoupler sensing OUTPUT : 7 outputs, open collector output (negative logic) SERVICE switch [SV/NM] (for maintenance purposes) Normally, this switch is used as the "NM" position. Ambient operating temperature Humidity Power requirements Current consumption Dimensions (W H D) Mass 0 °C to 40 °C (32 °F to 104 °F) 10 % to 90 % (no condensation) DC 12 V 10 % (AC adapter provided) 2.0 A (DC 12 V) 210 67 177 mm (8-1/4˝ 2-5/8˝ 6-15/16˝) [excluding protrusions] 1.4 kg (3.08 lbs.) Supplied AC adapter Rated input: AC 100 V to 240 V, 1.3 A, 47 Hz to 63 Hz Rated output: DC 12 V, 3.5 A, 42 W The provided power cable is for 125 V AC or less. Use it within AC 100 V to 120 V. The AC adapter and power cable provided must be used without fail. Mass and dimensions shown are approximate. Specifications are subject to change without notice. 33