Panasonic BT-LH1710 User Manual - Page 20

Main Menu (continued) VIDEO CONFIG Sub menu GAMMA SELECT*1*2 Settings STANDARD FILM STDIO/PST FILM GAMMA*2 COLOR TEMP. VARICAM OTHER USER0 - 63*5 D93 D65 D56 VAR1 VAR2 VAR3 SHARPNESS MODE*2 SHARPNESS H*2 HIGH*3 LOW 0 - 30*3 SHARPNESS V*2 0 - 30*3 I-P MODE*2*6 MODE2 MODE1 MONO*2 OFF ON ANAMO*2*7 SD ASPECT*2 SCAN*2 OFF ON 4:3 16:9 NORMAL UNDER Underlined values indicate factory defaults. Description Selects gamma curve. Standard mode Film mode Color emphasis mode (a mode that approximates CRT display capability suitable for studio or postproduction application) The mark appears at the top left of the screen when "FILM" is selected. Selects type of FILM gamma mode. For VARICAM use Other Selects color temperature. Adjustable settings 0 - 63 (equivalent to a color temperature range of 3,000 - 9,300K) Equivalent to a color temperature of 9,300K Equivalent to a color temperature of 6,500K Equivalent to a color temperature of 5,600K WB adjustment mode*4 WB adjustment mode*4 WB adjustment mode*4 Selects the width of outline correction edge. Thin edge Wide edge Sets horizontal outline correction. The item display moves to the lower part of the screen during adjustment. Sets vertical outline correction. The item display moves to the lower part of the screen during adjustment. Selects IP conversion mode. (J page 21, "IP mode") Inter-field interpolation Inter-frame interpolation Switches between color and monochrome (MONO). Color Monochrome * When ON, the CHROMA setting of the picture adjusting knob is fixed at 0. With an Anamo lens and SDI 720/60P, 59.94P input, the picture is resized to Anamo magnification (the vertically enlarged signal can be vertically compressed and corrected for display). Sets the aspect ratio for SD signal input. 4:3 display 16:9 display Sets under-scan and normal display. Normal display Under-scan *1 In split-screen display, changes are not reflected to the still image in the main window. *2 These functions are not available when "RGB-COMP." under "YPBPR/RGB" or "DVI-COMP." under "DVI-D" is selected in the "INPUT SELECT" menu (J page 30). *3 The following sharpness values are available and the settings for the selected input signal is displayed. Adjustment status during selection appears at the bottom right of the screen. 1) VIDEO system input (VIDEO) (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS H/V: 0) 2) HD for any other input (the factory defaults are SHARPNESS MODE: HIGH and SHARPNESS H/V: 0). 3) SD for any other input (the factory defaults are SHARPNESS MODE: LOW and SHARPNESS H/V: 0). *4 Selecting "VAR1", "VAR2" and "VAR3" engages the WB adjustment mode (J page 21). *5 To select USER0 - 63, 1) Press [ENTER] ("USER" changes to blue). 2) Use [ , ] to select 0 - 63 and press [ENTER]. *6 To use the "SUB WINDOW" (J page 25) function, 1) Change settings after exiting the "SUB WINDOW" function. 2) It is recommended to use "MODE2" for handling fast video. *7 "SCAN" changes are not reflected in Anamo size display. 20