Panasonic PT40LC12 Multi-media Display - Page 20
BASIC OPERATION, POWER ON/OFF, Initial Setup - won t power
UPC - 037988974474
View all Panasonic PT40LC12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Power ON and OFF Initial Setup First, check the connection of the Plug to the Wall Outlet and the Antenna/Cable to the RF in Terminal. (PP. 12-14.) If using Cable Box, DSS Receiver, or VCR, • Turn on Cable Box. • Turn off DSS Receiver, or VCR. 1 Press the POWER button to turn the projection display on. (Refer to page 21 for "Turning the Power ON and OFF".) Automatic Channel Setting is performed. CH AUTO SET PROCEED ING Note: To cancel AUTO SET in progress, press the SWAP button. Case 1 When setup is complete, the lowest channel picture appears. Case 2 If setup is incomplete, the following screen appears. Check connection of Antenna/Cable to the RF in Terminal, then try Automatic Channel Setting again. (PP. 24, 25) NO CH FOUND PLEASE CHECK ANTENNA CABLE CONNECT I ON THEN PRESS ACT I ON KEY AGAIN Note: When the unit is turned on for the first time, Automatic Channel Setting is performed. 20 For assistance, please call : 1-888-VIEW PTV(843-9788)