Panasonic PT40LC12 Multi-media Display - Page 7
Accessories, Remote Control Battery Installation, Helpful Hint - filter
UPC - 037988974474
View all Panasonic PT40LC12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Getting Started Accessories (1) Remote Control (EUR7603Z80) (2) Batteries 2 "AA" (3) RGB Cable (2 m) (LSJA0239-1 or LSJA0443) (4) Accessory Air Filter (LSYC0239) Before Using Remote Control Battery Installation Requires two AA batteries (supplied). 1.Turn the Transmitter face down. Remove top cover by pressing down on marking and sliding cover off in the direction indicated. 2.Install the batteries as shown in the battery compartment. (Polarity + or - must match the markings in the compartment). 3.Replace the cover and slide in reverse until the lock snaps. Two AA size Helpful Hint: For frequent remote control users, replace old batteries with Alkaline batteries for longer life. Precaution on battery use Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter. Observe the following precautions: 1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set. 2. Do not mix battery types (example: "Zinc Carbon" with "Alkaline"). 3. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. 4. Battery replacement is necessary when the remote control acts sporadically or stops operating the projection display set. Helpful Hint: Whenever you remove the batteries, you may need to reset the remote control infrared codes. We recommend that you record the code on page 62, prior to setting up the remote. 7