Panasonic SCHTB550 SCHTB550 User Guide - Page 27

Others The following settings are unnecessary under general usage conditions of the system. ∫ Remote control code When other Panasonic devices respond to this system's remote control, change the remote control code on the main unit and the remote control. Preparation ≥ Turn off all other Panasonic products. ≥ Turn on the main unit. Change the remote control code to code 2: 1 Aim the remote control at this system's remote control sensor. 2 Press and hold [MUTE] and [ ] on the remote control for more than 4 sec. ≥ All the indicators will blink for 10 sec when the code of this system is changed. ≥ The setting is maintained until it is changed again. ≥ If this system does not operate after changing the code, repeat steps 1 and 2. ≥ To change the remote control code to code 1, repeat the steps above, but replace [ ] with [TV]. ∫ To reduce the clear-mode dialog effect When the dialog does not sound natural while the volume is set low, for example, It is possible to reduce the dialog enhancing effect as follows: Press and hold [TV] on the remote control and followed by [s VOL] on the main unit for more than 2 sec. ≥ All the indicators will blink once when the clear-mode dialog effect is reduced. ∫ To turn off VIERA Link "HDAVI Control" When "HDAVI Control" compatible equipment does not work well with this system, for example, it is possible to turn off this function as follows: ≥ When VIERA Link is turned off the ARC function is not available. Be sure to connect the optical digital audio cable. (> 19) 1 Press and hold [MUTE] on the remote control and followed by [s VOL] on the main unit for more than 2 sec. 2 After the setting has changed, turn off all the connected devices and then turn them on again. ≥ All the indicators will blink once when VIERA Link "HDAVI Control" is turned off. ∫ To turn off the volume limitation If a state of the lowered volume disturbs you every time this system turns on, for example, it is possible to turn off this function as follows: Press and hold [MUTE] on the remote control and followed by [VOL r] on the main unit for more than 2 sec. ≥ All the indicators will blink once when the volume limitation is turned off. The settings of the clear-mode dialog effect, VIERA Link "HDAVI Control", and the volume limitation remain intact even if you switch this system to standby mode. To turn these 3 functions back on, this system must be set back to the factory preset. (> 28) ≥ Even if clear-mode dialog effect is reduced, dialog effect level is still adjustable. Operations 27 RQT9660