Panasonic VDRM55 Dvd Video Camera-oem - Page 48

Removing Disc 1 Press down the DISC EJECT lever once and release it. In a moment, the cover of disc insertion compartment will open slightly. 2 Open the cover by hand and remove the disc. Note: • It is recommended that you turn the DVD Video Camera off before inserting or removing disc to prevent misoperation. • If the disc cover is open, the power will not turn off even if the power switch is set to "OFF". • Do not remove the battery pack or disconnect the AC adaptor during removal of the disc or until power is completely turned off: If you do, the disc cover will not open. If this happens, reattach the battery pack or AC adaptor, push down the DISC EJECT lever once, and then release it. • Do not insert anything other than the 8 cm DVD-RAM or DVD-R disc into the disc insertion block: Doing so could cause malfunctions. • Set the power switch to "OFF" to turn the DVD Video Camera off. • When inserting or removing the disc, connect a charged battery pack or AC adaptor to the DVD Video Camera: The disc cover will not open unless the DVD Video Camera is powered. While pressing Pickup lens down on the spindle, grasp the edge of the disc and gently lift it out. Note: • Do not use excessive force when opening the cover. • Do not touch the pickup lens or the recording/ playback side of the disc. • If the disc cover is open, the power will not turn off even if the power switch is set to "OFF". • When you open the lid, the ACCESS/PC indicator flashes red. Do not leave the lid open. 3 Gently push the section labelled "PUSH CLOSE" on the cover of disc insertion compartment (on side) to close the cover. 48