Panasonic WJ-HD616/1000 Installation Guide - Page 44
About the connectors
View all Panasonic WJ-HD616/1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
About the connectors How to use the terminals of the ALARM/CONTROL connector These terminals are used for emergency recording, auto time adjustment and when installing a buzzer, a lamp or a similar alarm device. The connector to be used should be compatible with the pin array. 13 1 Pin array The pin array is different from other digital disk recorders. Make sure that the connection is correct referring to the following. ALARM/CONTROL 25 14 Pin No. Signal 1 Alarm output 8 2 Alarm output 9 3 Alarm output 10 4 Alarm output 11 5 Alarm output 12 6 Alarm output 13 7 Alarm output 14 8 Alarm output 15 9 Alarm output 16 10 N/A 11 Alarm reset input 12 Emergency recording input 13 Signal ground 14 Signal ground 15 Available disk space warning output 16 HDD error output 17 Camera error output 18 Error output 19 Outage processing end output 20 Time adjustment I/O 21 Sequence switchover I/O 22 Alarm suspension input 23 Outage detection input 24 External recording mode switching input 25 +5 V output Operation Alarm signal will be supplied at an event occurrence Remarks Open collector output 24 V DC max., -100 mA Canceling the alarm display Starting emergency recording signal input Non-voltage make contact input/5 V pull-up Signal output for available (remaining) disk space warning of the normal recording area/event recording area/copy area Signal output upon detection of an HDD error Signal output upon detection of a camera error Signal output upon detection of a recorder error Signal output upon completion of outage processing According to the signal input, the time of this recorder will be generated as the signal output, and then the time of all other recorders is adjusted to the time of this recorder. According to the signal input, the sequence operation will be switched and the signal output will be generated upon the sequence switchover. The state of the alarm suspension is assigned according to the signal input. Start the outage processing according to the signal input. Changeover to the external recording mode Open collector output/ 24 V DC max., - 100 mA High (+12 V) 12 mA 30 kΩ, 5 V pull-up, Output current - 100 mA/Non-voltage make contact input Non-voltage make contact input/5 V pull-up, -100 mA +5 V output 200 mA max. 44