Pfaff coverstyle 4850 Owner's Manual - Page 28
Important note on threading, Changing a spool on a threaded machine
View all Pfaff coverstyle 4850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Important note on threading The needle(s) must always be threaded last so that the needle threads do not run under the looper thread as seen in drawing 1, but instead over the looper thread as depicted in drawing 2. Should this sequence not be followed, thread breakage or missed stitches can occur. If the looper threads break, you must pull the needle threads out of the needle eye, rethread the loopier thread and then rethread the needle threads. Changing a spool on a threaded machine Cut the threads off close to the spool and replace with new spools. Tie together the threads which are still in the machine with the new threads, and pull the threads out of the needle eyes. Raise the presser foot. Pull on the needle threads until the knots are about 6 inches (15 cm) past the last thread guide in front of the needles. Cut the knots off and pull the threads through the respective needle eyes. The looper threads can be pulled continuously past the looper eye and placed to the left underneath the presser foot. 24