Philips Fisio 120 User Manual - Page 26

Troubleshooting PROBLEM SOLUTION The phone does not switch on Remove and reinstall the battery (see page 3). Then charge the phone until the battery icon has stopped flashing. Finally, unplug from the charger and try to switch the mobile on. The display shows BLOCKED when you switch on The n and q symbols are not displayed Somebody tried to use your phone but didn't know the PIN code nor the unblocking code (PUK). Contact your service provider. The network connection is lost. Either you are in a radio shadow (in a tunnel or between tall buildings) or you are outside the network coverage area. Try from another place or contact your operator for assistance or information about the network. The display doesn't respond (or responds slowly) to key pushes The display responds more slowly at very low temperatures. This is normal and does not affect the operation of the phone. Take the phone to a warmer place and try again. In other cases please contact your phone supplier. Your phone doesn't Make a long press on e, or switch off the phone, check that both go to idle screen SIM card and battery are installed correctly, and switch it on again. Your phone doesn't This feature is network and subscription dependent. If the network display the phone doesn't send the caller's number, the phone will display Call 1 numbers of callers instead. Contact your operator for detailed information. You can't send text Some networks don't allow message exchanges with other messages networks. Contact your operator for detailed information. When charging, the battery icon shows no bars, outline is flashing Only charge the battery in an environment where the temperature does not go below 0°C (32°F) or above 50°C (113°F). In other cases please contact your phone supplier. 24