Philips MCD515 User manual - Page 21

21

English

Preparations

IMPORTANT!

–

Make sure to complete the

preparation procedures before operating

the system.

Step 1:

Inserting batteries into

the remote control

1

Open the battery compartment.

2

Place two batteries (Type R06 or AA) in the

compartment with the correct polarity as

indicated by “+” and “–” symbols.

3

Close the cover.

Using the remote control to operate the

system

1

Point the remote control directly at the remote

sensor (iR) on the front panel.

2

Select the source you wish to

control by pressing one of the

source select buttons on the

remote control (for example

DISC,TUNER).

3

Then select the desired function

(for example

2;

,

í

,

ë

).

CAUTION!

–

Remove batteries if they are

exhausted or will not be used for a long

time.

–

Do not use old and new or different

types of batteries in combination.

–

Batteries contain chemical substances,

so they should be disposed of properly.

Step 2:

Setting the clock

1

Go to Standby mode.

2

Press and hold

CLOCK SET

on the front

panel.

➜

“

SET CLOCK

” is displayed briefly. Then, the

hour digits flash on the display screen.

3

Turn the

VOLUME

control on the front panel

or press

VOL +/-

on the remote to set the

hours.

4

Press

CLOCK SET

again.

➜

The minute digits flash on the display screen.

5

Turn the

VOLUME

control on the front panel

or press

VOL +/-

on the remote to set the

minutes.

6

Press

CLOCK SET

to confirm the clock

setting.

Notes:

–

This system only supports 24-hour mode.

–

The clock setting will be erased when the system

is disconnected from the power supply.

–

The system will exit clock setting mode if no

button is pressed within 30 seconds.

T

PRESET

Philips MCD515 User manual - Page 21

Preparations

Page 21 highlights