Pioneer FH-P5000MP Installation Manual - Page 38
Using subwoofer output, Audio Adjustments, Adjusting subwoofer low pass, filter settings
View all Pioneer FH-P5000MP manuals
Add to My Manuals
Save this manual to your list of manuals |
3
Push Multi Control down to turn loud-
ness off.
Loud :OFF
appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off. When a sub-
woofer is controlled with this unit, first, switch
the RCA output setting to subwoofer, then
turn the subwoofer output on. For more de-
tails, see
Switching the RCA output setting
on
page 47.
1
Press AUDIO to select SUB.W.
Press
AUDIO
until
SUB.W
appears in the dis-
play.
#
When the RCA output setting is
P/O:S/W
, you
can select
SUB.W
.
2
Push Multi Control up to turn subwoo-
fer output on.
SUB.W:ON
appears in the display. Subwoofer
output is now on.
#
To turn subwoofer output off, push
Multi Control
down.
3
Push Multi Control left or right to select
the phase of subwoofer output.
Push
Multi Control
left to select reverse
phase and
Phase:REV
appears in the display.
Push
Multi Control
right to select normal
phase and
Phase:NOR
appears in the display.
Adjusting subwoofer (low pass
filter) settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1
Press AUDIO to select 80.
Press
AUDIO
until
80
(subwoofer cut-off fre-
quency) appears in the display.
#
When the subwoofer output is on, you can se-
lect
80
.
#
If the subwoofer setting has been previously
adjusted, the frequency of that previously se-
lected will be displayed instead of
80
.
2
Push Multi Control left or right to select
cut-off frequency.
Each pushing
Multi Control
left or right se-
lects cut-off frequencies in the following order:
50
³
63
³
80
³
100
³
125
³
160
³
200
(Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3
Push Multi Control up or down to ad-
just the output level of the subwoofer.
Each pushing
Multi Control
up or down in-
creases or decreases the level of the subwoo-
fer.
+6
±
±
24
is displayed as the level is
increased or decreased.
Adjusting low pass filter
attenuation slope
When the subwoofer output is on, you can ad-
just the continuity of sound between speaker
units.
1
Press AUDIO to select SLOPE.
Press
AUDIO
until
SLOPE
(subwoofer slope)
appears in the display.
#
When the subwoofer output is on, you can se-
lect
SLOPE
.
2
Push Multi Control left or right to select
slope.
Each pushing
Multi Control
left or right se-
lects slopes in the following order:
6
³
12
³
18
(dB/oct.)
Audio Adjustments
En
38
Section
09