Pioneer FH-P5000MP Installation Manual - Page 42
Digital Signal Processor, Adjusting equalizer curves, Adjusting 13-band graphic, equalizer
View all Pioneer FH-P5000MP manuals
Add to My Manuals
Save this manual to your list of manuals |
1
Press DSP to select the graphic equali-
zer.
Press
DSP
until
PWRFL
appears in the display.
#
If the graphic equalizer has been previously
set to an equalizer curve other than
PWRFL
then
the title of that previously selected equalizer
curve will be displayed instead of
PWRFL
.
2
Push Multi Control left or right to select
an equalizer curve.
Each pushing
Multi Control
left or right se-
lects equalizer curves in the following order:
PWRFL
³
NTRL
³
VOCAL
³
FLAT
³
CTM1
³
CTM2
³
S-Bas
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of
FLAT
, can be adjusted to a fine
degree (nuance control).
1
Recall an equalizer curve.
See
Recalling equalizer curves
on the previous
page.
2
Push Multi Control up or down to ad-
just the equalizer curve.
Each pushing
Multi Control
up or down in-
creases or decreases the equalizer curve re-
spectively.
+6
±
±
5
(or
±
6
) is displayed as the equalizer
curve is increased or decreased.
#
The actual range of the adjustments are differ-
ent depending on which equalizer curve is se-
lected.
#
The equalizer curve with all frequencies set to
0
cannot be adjusted.
Adjusting 13-band graphic
equalizer
For
CTM1
and
CTM2
equalizer curves, you
can adjust the level of each band.
!
A separate
CTM1
curve can be created for
each source. (The built-in CD player and
the multi-CD player are set to the same
equalizer adjustment setting automati-
cally.) If you make adjustments when a
curve other than
CTM2
is selected, the
equalizer curve settings will be memorized
in
CTM1
.
!
A
CTM2
curve can be created common to
all sources. If you make adjustments when
the
CTM2
curve is selected, the
CTM2
curve will be updated.
1
Recall the equalizer curve you want to
adjust.
See
Recalling equalizer curves
on the previous
page.
2
Press DSP to select 13-band graphic
equalizer.
Press
DSP
until
50
appears in the display.
#
If 13-band graphic equalizer has been pre-
viously adjusted, the frequency of that previously
selected will be displayed instead of
50
.
3
Push Multi Control left or right to select
the equalizer band to adjust.
Each pushing
Multi Control
left or right se-
lects equalizer bands in the following order:
50
³
80
³
125
³
200
³
315
³
500
³
800
³
1.25k
³
2.0k
³
3.15k
³
5.0k
³
8.0k
³
12.5k
(Hz)
4
Push Multi Control up or down to ad-
just the level of the equalizer band.
Each pushing
Multi Control
up or down in-
creases or decreases the level of the equaliza-
tion band.
+6
±
±
6
is displayed as the level is increased
or decreased.
#
You can then select another band and adjust
the level.
Digital Signal Processor
En
42
Section
10