Pioneer P7600DVD Owner's Manual - Page 13

Before You Start Section 02 Before You Start When an operation is prohibited When you are watching a DVD and attempt to perform an operation, it may not be performed because of the programming on the disc. When this happens, the icon appears on the screen. ! The icon may not appear with certain discs. tion may not be possible even if you press RESET. ! After completing connections or when you want to erase all memorized settings or return the unit to its initial (factory) settings, switch your engine ON or set the ignition switch to ACC ON before pressing RESET. Resetting the microprocessor Pressing RESET lets you reset the microprocessor to its initial settings without changing the condition memory. The microprocessor must be reset under the following conditions: ! Prior to using this unit for the first time after installation ! If the unit fails to operate properly ! When strange or incorrect messages ap- pear on the display 1 Turn the ignition switch OFF. 2 Press RESET with a pen tip or other pointed instrument. Use and care of the remote control Installing the battery Slide the tray out on the back of the remote control and insert the battery with the plus (+) and minus () poles pointing in the proper direction. ! When using for the first time, pull out the film protruding from the tray. WARNING Keep the battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor. RESET button Notes ! When using with a Pioneer navigation unit, if you press RESET, be sure ACC OFF is selected. If ACC ON is selected, correct opera- CAUTION ! Use only one CR2025 (3 V) lithium battery. ! Remove the battery if the remote control is not used for a month or longer. ! Do not recharge, disassemble, heat or dispose of the battery in fire. ! Do not handle the battery with metallic tools. ! Do not store the battery with metallic materi- als. En 13