Pioneer P7600DVD Owner's Manual - Page 78

Section 15 Audio Adjustments 3 Touch PANORAMA and then touch d to turn the Panorama control on. # To turn the Panorama control off, touch c. 4 Touch DIMENSION and then touch c or d to adjust front/surround speaker balance. Each time you touch c or d it moves the sound towards the front or the surrounds. +3  3 is displayed as the front/surround speaker balance moves from front to surrounds. 5 Touch CENTER WIDTH and then touch c or d to adjust the center image. Each time you touch c or d it gradually spreads the center channel sound into the front left and right speakers over a range 07. 3 is the default and its recommended for most recordings. 0 places all center sound in the center speaker. 7 places all center sound equally in the left/right speakers. Setting the speaker setting You need to make with/without (or yes/no) and size (bass reproducing capacity) selection/adjustments depending on the installed speakers. The size needs to be set to LARGE (large) if the speaker is capable of reproducing sounds of about 100 Hz or below. Otherwise select SMALL (small). ! Low frequency range is not output if the subwoofer is set to OFF and the front and rear speakers set to SMALL or OFF. ! It is imperative that non-installed speakers be set to OFF. ! Set the front or rear speaker to LARGE if the speaker is capable of reproducing bass content, or if no subwoofer is installed. 1 Touch A.MENU and AUDIO and then touch Sound Setting. 2 Touch SP SET. 3 Touch the speaker to be adjusted. 4 Touch a or b to select the correct size for the selected speaker. Each time you touch a or b it selects the size in the following order: OFF (off)SMALL (small)LARGE (large) # You cannot select OFF, when the front speakers have been selected. # You can turn ON or OFF, when the subwoofer has been selected. Correcting the subwoofers phase If trying to boost the bass output of the subwoofer doesnt do much or rather makes you feel that the bass gets more murky, this may indicate that the subwoofers output and bass content you hear over other speakers cancel each other out. To remove this problem, try changing the phase setting for the subwoofer. 1 Touch A.MENU and AUDIO and then touch Sound Setting. 2 Touch SP SET. 3 Touch the subwoofer. 4 Touch a to turn subwoofer output on. # To turn subwoofer output off, touch b. 5 Touch c or d to select the phase of subwoofer output. Touch d to select normal phase and NORMAL appears in the display. Touch c to select reverse phase and REVERSE appears in the display. 78 En