Pioneer P7600DVD Owner's Manual - Page 97
Troubleshooting, Additional Information
UPC - 012562745602
View all Pioneer P7600DVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Additional Information Appendix Additional Information Troubleshooting Common Symptom Cause Action (See) Power doesnt turn on. The unit doesnt operate. Leads and connectors are incorrectly connected. Confirm once more that all connections are correct. The fuse is blown. Rectify the reason for the fuse blowing, then replace the fuse. Be very sure to install the correct fuse with the same rating. Noise and other factors are causing Press RESET. (Page 13) the built-in microprocessor to operate incorrectly. Operation with the remote con- The remote control operation mode trol isnt possible. is incorrect. The unit does not operate cor- The remote control code is incor- rectly even when the appropriate remote control buttons are rect. pressed. Battery power is low. Switch to the correct remote control mode. (Page 18) Make sure the remote control selection switch setting and code type setting are the same. (Page 87) Load new battery. (Page 13) Some operations are prohibited with certain discs. Check by using another disc. Playback is not possible. The disc is dirty. Clean disc. (Page 101) The loaded disc is a type this unit cannot play. Check what type the disc is. Non compatible video system disc Change to a disc compatible to your video is loaded. system. No sounds are heard. The volume level will not rise. Cables are not connected correctly. Connect the cables correctly. The unit is performing still, slow mo- There is no sound during still, slow motion or tion or frame-by-frame playback. frame-by-frame playback. The front, rear, left and right speak- Adjust the relative levels between the speakers are not properly adjusted in level ers correctly. (Page 76) balance. Sound is not heard over a speci- The speaker size is set to OFF. fic speaker. Make the correct size setting for the speaker. (Page 78) The speaker level is set too low. Increase the speaker level setting to get the balance right with the other speakers. (Page 79) The center speaker size is set to Set the center speaker size to OFF. (Page 78) SMALL or LARGE whereas no cen- ter speaker is installed. There is no picture. The parking brake cord is not con- Connect a parking brake cord, and apply the nected. parking brake. The parking brake is not applied. Connect a parking brake cord, and apply the parking brake. En 97