Poulan 1994-04 User Manual - Page 18
Caccessories
View all Poulan 1994-04 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
3. Installing Line on Spool To replace the Line on existing Spool: a. Follow "Installing Spool w/Line," steps "a. - d." and remove any line remaining on the spool. b. Use a 40 foot length of .080" WEED EATER brand line. c. Insert 1/16" to 1/8" of the end of the line through the hole in the spool. Figure 24 . Allow no more than 1/8" line to extend inside the spool. d. Wrap the line onto the spool firmly and evenly in the direction shown by the arrow on the spool. Figure 24 . NOTE: The line must be wrapped firmly and evenly for proper line feed. e. Follow "Installing Spool with Line," steps a C Lug Lug NORMAL SPOOL Figure 23 WORN SPOOL For best results, use only .080" WEED EATER brand line. If the line breaks off or backs up in the trimmer head, follow "Installing Spool w/Line," steps "a. -d." Pull slack in line until the line is tightly wound on the spool, leaving 4-6 inches of extended line. Continue with steps "e. - i." Wrap Line on Spool as Shown by Arrow 1/8" o Line Figure 24 4. Trouble Shooting the Trimmer Head and Line • Does not advance or breaks while cutting: - Improperly wound onto spool. - Line size incorrect. - Too little line outside head. • Pulls back into head: - Too little line outside of head. • Welds onto spool: - Line size incorrect. - Incorrect spool. - Crowding line against material being cut. - Cutting at higher speeds than necessary. ACCESSORIES ITEM SAFETY FACE SHIELD SAFETY GLASSES SAFETY LEG GUARDS REPLACEMENT BLADE WEED EATER® 40:1 2-CYCLE ENGINE OIL - -3.2 oz. - -8 oz - -19.6 oz. FUEL CAP TAP-N- GO I TRIMMER HEAD SPOOL W/LINE WEED EATER NYLON CUTTING LINE (.080 Dia.) - -80 Ft. - -200 Ft. - -400 Ft. FLEX SHAFT LURE AIR FILTER SPARK PLUG STOCK NO. 952-701601 952-701645 952-701600 952-701546 952-030133 952-030128 952-031138 952-701583 952-701574 952 -701523 952-701534 952-701595 952-701590 952-701570 952-701614 530-030077 - 18 -