ProForm 14.0 Ce Elliptical English Manual - Page 9

6. Identify the Right Pedal (14), the Right Gel Pad (90), and the Right Pedal Arm (12) assembly, 6 which are marked with “"Right”" stickers, and ori- ent them as shown. Set the Right Gel Pad (90) on the Right Pedal Arm (12). Then, set the Right Pedal (14) on the Right Gel Pad. Attach the Right Pedal (14) to the Right Pedal Arm (12) with two M6 x 12mm Screws (111) and two M6 Washers (112); do not tighten the Screws yet. Next, tighten two M6 x 50mm Screws (62) with two M6 Washers (112) into the Right Pedal Arm (12) and the Right Pedal (14). Then, tighten the two M6 x 12mm Screws (111). Attach the Left Pedal (not shown) to the Left Pedal Arm (not shown) assembly in the same way. 14 90 12 112 111 112 62 7. Apply grease to the axle on the right Crank Arm (39). 7 Orient a Pedal Arm Sleeve (46) so that the flat side is facing the elliptical. Slide the Pedal Arm Sleeve onto the axle on the right Crank Arm (39). Attach the Pedal Arm Sleeve (46) with an M8 x 25mm Screw (121), a Large Axle Cover (113), and an M8 Washer (95). Tip: Avoid damaging the Large Axle Cover when tightening the Screw. Repeat this step on the other side of the elliptical. Grease 39 Flat Side 46 95 113 121 9