ProForm 405 Ce Elliptical English Manual - Page 10

Attach the Left Upper Body Arm 9 to

Get ProForm 405 Ce Elliptical PDF manuals and user guides View all ProForm 405 Ce Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

9. Identify the Right Upper Body Arm (8), which is marked with a “"Right”" sticker, and orient it as shown. Attach the Right Upper Body Arm (8) to the Right Upper Body Leg (6) with three M8 x 16mm Screws (102) and three M8 Split Washers (103). Attach the Left Upper Body Arm (9) to the Left Upper Body Leg (7) in the same way. 9 9 7 6 8 103 103 102 10. Identify the Right Handlebar (10), which is marked with a “"Right”" sticker, and orient it as 10 shown. Have a second person hold the Right Handlebar (10) near the right side of the Upright (5). Avoid pinching the Sensor Wire (34) Locate the indicated wire tie in the Upright (5). Tie the lower end of the wire tie to the Sensor Wire (34) inside the Right Handlebar (10). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: Avoid pinching the Sensor Wire (34). Attach the Right Handlebar (10) to the Upright (5) with two M8 x 16mm Screws (102) and two M8 Split Washers (103). Attach the Left Handlebar (11) in the same way. 11 Wire Tie 34 5 10 103 102 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
10
10
10. Identify the Right Handlebar (10), which is
marked with a ±Right² sticker, and orient it as
shown.
Have a second person hold the Right Handlebar
(10) near the right side of the Upright (5).
Locate the indicated wire tie in the Upright (5).
Tie the lower end of the wire tie to the Sensor
Wire (34) inside the Right Handlebar (10). Next,
pull the upper end of the wire tie upward out of
the top of the Upright. Then, untie and discard
the wire tie.
Tip: Avoid pinching the Sensor Wire (34).
Attach the Right Handlebar (10) to the Upright
(5) with two M8 x 16mm Screws (102) and two
M8 Split Washers (103).
Attach the Left Handlebar (11) in the same
way
.
102
103
34
10
11
5
Wire Tie
Avoid pinching the
Sensor Wire (34)
9
8
6
7
9
102
103
103
9.
Identify the Right Upper Body Arm (8), which
is marked with a ±Right² sticker, and orient it as
shown.
Attach the Right Upper Body Arm (8) to the
Right Upper Body Leg (6) with three M8 x 16mm
Screws (102) and three M8 Split Washers (103).
Attach the Left Upper Body Arm (9) to the
Left Upper Body Leg (7) in the same way
.