ProForm 405 Ce Elliptical English Manual - Page 8

5. Using a small plastic bag to keep your fingers clean, apply a generous amount of the included grease to the Upright Axle (48) and to two Small Wave Washers (118). Insert the Upright Axle (48) into the Upright (5) and center it. Slide a Small Wave Washer (118) onto each end of the Upright Axle. Identify the Right and Left Upper Body Legs (6, 7), which are marked with “"Right”" and “"Left”" stickers, and orient them as shown. Slide the Right and Left Upper Body Legs (6, 7) onto the Upright Axle (48). Tighten two M8 x 16mm Screws (102) with two M8 x 25mm Washers (45) into the ends of the Upright Axle (48) at the same time. Firmly tighten the Screws. 5 102 45 7 118 Grease 5 6 118 Grease 48 45 102 6. Apply grease to the axle on the Right Upper Body Leg (6) and to a Large Wave Washer 6 (116). Slide a Leg Spacer (55) and the Large Wave Washer (116) onto the Right Upper Body Leg (6). Make sure that the flat side of the Leg Spacer is facing outward. Identify the Right Pedal Arm (12), which is marked with a “"Right”" sticker, and orient it as shown. Slide the Right Pedal Arm onto the Right Upper Body Leg (6). Attach the Right Pedal Arm (12) with an M8 x 16mm Screw (102), an Axle Cover (56), and an M8 x 25mm Washer (45). Repeat this step on the other side of the elliptical. 6 Grease 55 12 116 45 56 102 Flat Side 8