ProForm 7.0 Re Elliptical English Manual - Page 22
See EXPLODED DRAWING B on Using
View all ProForm 7.0 Re Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
HOW TO ADJUST THE DRIVE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. Loosen the Pivot Screw (81). Then, tighten the Drive Belt Adjustment Screw (72) until the Drive Belt (46) is tight. To adjust the drive belt, you must remove the shield cover and the left shield (see the instructions below). See EXPLODED DRAWING B on page 27. Using a flat screwdriver, release the tabs along the sides of the Shield Cover (37), and then remove the Shield Cover. Next, remove the M4 x 16mm Screws (64) and the M4 x 19mm Screws (61) from the Left and Right Shields (44, 45). Make sure to note which size of Screw you remove from each hole. Then, gently remove the Left Shield. 46 81 72 When the Drive Belt (46) is tight, tighten the Pivot Screw (81). Then, reattach the left shield and the shield cover. 22